Wash plastics, remove wax, oils, adhesive residue, and dirt. Let everything dry completely.
Clean prep. Calm hands.
Good installation starts before the graphic touches the plastic. Work slowly, keep surfaces clean, and use heat with intention.
001 / Install Sequence
From surface to final seal.
These are general guidelines. Complex curves, old plastics, or specialty finishes may need extra patience.
Position each piece before peeling backing. Use bolt holes, panel edges, and body lines as your map.
Use light pressure at first, then firm passes. Push air outward and avoid trapping tension into curves.
Warm edges and complex curves, then press again. Let the kit rest before washing or heavy riding.
What tools should I have ready?
A clean microfiber towel, surface cleaner, squeegee, low heat source, and a sharp blade for careful trimming if needed.
Can I install over old graphics?
We recommend removing old graphics first. Old adhesive, lifted edges, and trapped dirt can shorten the life of the new kit.
When can I wash the bike?
Give the adhesive time to settle. Waiting at least 24 hours before washing is a good baseline, longer in cold conditions.
